Posted by Dan-IA on May 17, 2008 at 19:53:30 from (66.43.223.149):
I was always taught with a diesel you run it at a slow speed until it warms up, run it slow when it's idling (it uses practically no fuel at idle), but otherwise keep that engine wound up to 2800RPM, it has plenty of torque and you won't lug it or bend a crank or anything like that. And those tractor transmissions act like an ratcheting impact wrench on the final drives at too slow a speed, so run it fast to prevent damaging the bull gears.
Well, today I was in the field with a 4-150 pulling a tandem disk just deep enough to break up the topsoil and cut stalks (not more than 4 inches.) I was told to run it in 3rd wide open, but I got to thinking that 4th at about half throttle was plenty fast. It took virtually no power to pull that disk this way, and that big Cat 3208 engine was a lot quieter, so I could actually hear the radio for a change.
Does that sound reasonable, or was I abusing my equipment?
While I'm thinking about it, is there any hard and fast rule about what implements you're supposed to lift out of the ground to turn and which ones you can just drag around? I was taught to lift a disc, but the soil was loose enough on top today it didn't seem to hurt when I wasn't overly quick on the lift lever.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
