Posted by JMS/.MN on June 19, 2008 at 15:14:08 from (209.237.107.155):
In Reply to: Re: hitch conversion posted by Mike (WA) on June 19, 2008 at 13:42:20:
The Snap-Coupler IS the bell-shaped housing under the middle of the tractor- not on the lift arms. Common mistake in terminology. The linkage in the Snap-Coupler is what senses load and accomplishes draft control by slightly raising and lowering the lift arms, adding implement and soil weight to the rear wheels. There are washers next to the spring under the tractor- they are adjusted per specific factory measurement, and there is a linkage connected between that and the hydraulic pump. AC does not sense pull on the arms- all the arms do is raise and lower the implement. 3ph systems do sense pull on the arms. AC is upside down to that. As far as adapting to AC- the implement would hang 3 feet behind, no draft sensing, etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
