Tractor Talk Discussion Board |
Re: Tarping a tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Alberta Mike on February 22, 2000 at 15:01:14 from (198.161.119.4):
In Reply to: Tarping a tractor posted by Duane on February 20, 2000 at 04:48:30:
I've got a couple of restored tractors that I store under the blue (colored) polytarp that have the eyelets already in. Sometimes I add extra eyelets as needed to fit so tying it down is handy. BUT, before I tarp, I fabricated a wooden rail that is attatched (tied firmly) to the top of the steering wheel and the front of the wood sits at the front of the hood, preferably on top of the rad cap. You can make up some type of a rubber pad to hold it in place. This wooden piece can extend forward past the grille if you like. Next, drape a poly tarp over top and tie it down, preferably with a good quality cotton lace like a hockey skate lace (they are available up to 120"). Good tying locations are the wheels, axels, under the grille, drawbar, etc. If you've got a restored tractor, make sure the poly clears all panels, etc. The tie-down job must be tight. Rubbing (from wind) can do a lot of damage to a nice paint job. Check underneath when finished and make sure that your 'tent' clears all parts of the tractor. Air circulation is critical. A few strategically placed stockings (eg. over headlamps) or old towells (eg. over the grille) are helpful to reduce 'rubbing'.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|