Posted by Janicholson on February 03, 2009 at 21:47:43 from (68.112.156.69):
In Reply to: Farmall H pto posted by John B. on February 03, 2009 at 20:07:16:
1/2 rpm will be abpout 270RPM. thus to get to 1500 you need about a 5.5 to one overdrive. I would use no less than a 6" pulley on the compressor, so a 30+ inch pulley would be needed. Since this is too big, a double overdrive might be needed. say 12" to 6" then maybe 13 to 6". These are approximations. a manual shift car trans used backwards will give several gears of over drive usually one would be in the 4 to 5 to one range. Mount it on a trailer and mount the trans in front of it with the driveshaft going to the reversed trans. A shaft tachometer is not too expensive, or could be rented or borrowed. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
