I'd leave it sit overnight, then open the drain plug on the oil pan. See if you get water coming out or at least milky oil. Also see if ti smells like fuel... Given that there's no turbo on the old Lanz, I doubt that's the problem.
If it's not a head gasket issue, it's probably a fuel issue. I suspect that it probably blew an injector tip off, perhaps because of water in the fuel.
If there's no water in the oil, put the pug back and start the engine. Open the injector ines one at a time and see which one doesn't cause a loss of RPM or make theengine stagger. The one that doesn't is the bad cylinder. At that point you can pull the injector and look at it. If nothign obvious, swap the injector with one of the others and see if the problem follows the injector or stays in the cylinder... That way you know if it's a cylinder/compression problem or an injector problem. I'm betting on an injector given you have no power, smoke and increased oil level.... IF it's not a head gasket/liner issue... but you should find that the coolant is down and you'll find it in the oil.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
