Several posters have pointed out that there is no "instant" warm up with in-floor heating.
If I wasn't going to keep the heat on, I'd certainly use some type of anti-freeze in the tubing. My worry, without anti-freeze, would be expansion of the tubing when it froze. I think it would pop up the concrete over the tubing, much like a rebar rusting in a bridge deck.
My son built a 30X50 shop with hot water in-floor heat. It was nice - he used an electric boiler that looked suspiciously like an electric water heater. No anti-freeze, but we're in southern Illinois. He set the thermostat on the lowest setting and left it alone.
I worked with a guy who bought a house with in-floor hot water heat. Concrete floors, nice modern gas boiler. He was a tightwad, and waited 'til it got to 40 degrees before he turned the heat on. Took three days steady burning to get the house warmed up. Lotsa mass in that conc floor. Probably didn't save much money.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.