Posted by ryanwheelock on June 29, 2010 at 06:00:20 from (67.59.45.185):
Question about turning at the corners while mowing hay. Seems like most people always come to the end and make a left turn and raise the mower up and make a circle then lower and start cutting again, Is it bad to make a big sweeping turn to the right instead of pullng out and raising the head and circle to the left. If that makes sense. Is it just harder on the U-joints? My problem is my hydraulics have a problem and the head height is stuck at cutting height. If I try to circle around the already cut hay will plug the sickle. But seems like I get chatter in drive line turing either way. Thanks for the input Ryan PS After 4-5 weeks of rain finally get to cut some last night and then I find a wheel bearing that is bad on the haybine. Wish it would have had a grease fitting on it, it will when it gets repaired.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
