Posted by mkirsch on June 29, 2010 at 10:02:03 from (64.80.108.56):
In Reply to: Haybine turning posted by ryanwheelock on June 29, 2010 at 06:00:20:
Got no clue what you mean by "crescent."
If the driveline chatters, then you don't have your drawbar set correctly. It should be 14" from the tip of the tractor PTO shaft to the center of the drawbar hole, and the drawbar needs to be rigid.
Since I've been old enough to run the haybine, we always had a hydraulic cylinder on the hitch to "steer" the haybine around corners.
As you start around the corner, you "suck" the haybine in to keep it from turning too soon, and at about halfway around the corner you "push" the haybine back out to cutting position.
Done correctly, it leaves a perfect corner with no standing hay.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
