Looks to me like it would be much easier and cheaper to leave the house alone (provded its suitable) and just get a new seperate service and 100 or 200 amp (plenty of upgrade capacity) service and panel out at the shop. Thats exactly what I have. Provided the utility will furnish the shop service????????????? their expense is to the utility pole and transformer and all you have is the short secondary drop. THATS IFFFFFFFFFF THEY WILL DO THIS ?????????????????????????
If you run a branch circuit from house to shop you have to run 4 wires (2 Hots, Neutral, Equipment Ground) and thats alllllll your expense. It may or may not require some buried conduit depending on if you go under driveways etc. Dont forget grounding out at the shop
Also theres a limit as to the biggest size of a branch breaker you can feed out of a 150 or 200 amp main panel. If you upgraded the house to 200 amps you can easily run a 100 amp branch circuit out to the barn butttttttt if its only 150 at the house I dont see you providing 100 amps out to the shop.
STANDBY GENERATOR: Im assuming thats ONLY needed for the house right??? I suggest use of a Transfer Switch or else go with one of the cheaper lock out main breaker thingamagiggys. Of course, if you go the sub panel feed from the house (NO seperate shop service) you could have some emergency power out there.
I will post again once you decide on the approach you take.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
