Posted by Red Dave on November 22, 2010 at 08:38:18 from (66.216.141.163):
In Reply to: Re; JFK posted by msb on November 22, 2010 at 06:37:28:
A few years back I was in Dallas on business. I went out to the Texas Book Depository ( now a museum) one afternoon.
I stood at the window where Oswald is supposed to have shot from and looked down onto Dealey Plaza. One thing struck me immediately, that is how the shot would have lined up for Oswald. Dealey Plaza at that point goes downhill to go under the railroad tracks, it also turns a bit to the left at the top of the grade so that the traffic lanes come closer together as they go into the underpass, but the street is straight for about 150 feet right at the spot where the limo was during the shooting. What it does is force the Presidential Limo to go down a grade that is just about the same angle as Oswald would have had to hold the rifle as he aimed. The shot would have been on a down slope, going straight away from the shooter. The shot would line itself up, at less than 100 yards distance. Changing speeds in the limo would have no effect because the target was going straight away, not crossing from one side to the other. Any decent deer hunter could have made it.
I can't explain the "magic bullet". I don't know if there was a conspiracy, or if there was anybody on the "grassy knoll", or if Oswald was the one who fired the shots from that window, but he could have. That shot was not as big a deal as the so-called "experts" have claimed it was.
Go to Dallas, stand at the window, see for yourself. See what I saw. Anyone with some experience shooting and hunting will agree.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
