Rich, I am familiar with K10 having a 1980 myself, and I converted mine from an auto to a 4 speed, I think you mentioned using another transfer case and trans from another truck or different brand, kind of forget. I still have a good transfer case, and a bad auto sitting in the weeds, would certainly take a look to see if there was anything useful on it.
I was wondering how you made out with the Spicer hubs, mine had those, but had to be changed, when it was still on the road, I vaguely recall the parts diagram on these, was just wondering how that part of it went.
My ole K10, I replaced a motor with a rebuilt one, in 19 hours flat,( that was one long day) in early '91, then a few years later the auto went, I found a complete manual set up, pedals, trans/trans. case, cross member, was a low mileage rusted out earlier K series truck, for a few hundred, had the flywheel surfaced, new heavy duty clutch, still cannot believe I was able to do this job, mostly by myself, in one of the yards at work, best thing was the parts places and machine shop was nearby, great location to do the job, even if out side, couple of weekends it was done. The bad thing was I drove it out of NJ, up the NYS thruway, kinda just slapped some plates on it, got pulled over in NJ, talked my way out of it, she sits in my yard, what a great old truck, with that drive train I could knock trees over, just line them up with the plow frame, one thing is for sure, that truck may someday rust away, but I will keep that drive train for another. Mine has 270 gears in it, something was a bit off on the speedo when I put that 4 speed trans in it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
