Posted by Mac AR on October 25, 2016 at 11:50:44 from (162.104.73.117):
I had a little down time today, and I've been thinking (which is extremely dangerous): are the big gassers (like 4020s, 706s, 1855s, etc) really that thirsty compared to a diesel? I think the average on the Nebraska tests is 1 gallon more than the diesels. And, are they still feasible for someone that doesn't work one every day? I admit, I don't use a tractor every day. Almost, yes, but not each and every day, day in and day out. I normally put around 800 to 1000 hours on the clock a year, I think (don't know, neither of them have meters).
I ask all this because, I'm thinking I'd like to have a bigger horse. I'd love to have a 656, or 706. They're my first choice. My second would be one of the Oliver 50/55 series, or maybe a 3020 Deere. I'd like to have a cab, too, but thats not a deal breaker. Would I put myself in the poor house with the fuel bill? After this year, I'll be down to mowing twice a year and feeding in winter, so hours will be cut down to about 1/3 what they were. Will the increase in speed and ground coverage offset the increased (if any) fuel consumption? I know the 300 Farmall uses 3 to 3.5 gal/hr running my 6' brush cutter over about 2.5-3 ac/hr. I have found an 1850 gas that Nebraska says uses 7.7 gal/hr. That's awful thirsty, but having said that, I'd have about 80 pto HP instead of 42. I can pull a lot bigger mower. Or run my same mower faster, at a lower engine speed. Again, I don't know. Maybe I should just keep the 300 and the B JD and keep on keeping on.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.