Posted by Allan In NE on November 29, 2007 at 03:26:47 from (148.78.243.25):
In Reply to: Re: C4 auto question? posted by Hobo,NC on November 28, 2007 at 19:17:12:
Hmmm,
Well, I see where you coming from; but think you're in the right church, but maybe sitting in the wrong pew.
By moving the shift lever, you are either applying OR releasing the line pressure to the governor valve depending on the position of the manual shift valve. It's either an on or off thing.
You're trying to "shake/thump" the governor valve hydraulically by turning on, or turning off the supply of oil.
Likewise, movement of the flyweight is lateral and depends upon rotation/speed regardless of that shaft's direction. However, by reversing the shaft rotation, the governor valve/flyweight’s “movement” would then be independent of the effects of any oil pressure.
This is a ‘one-time’ hope/attempt at a fix. Trying to “jar it loose”, as it were. :>)
At any rate, the oil never "reverses, flushes or cleans". Ever. It's either flowing to the governor assembly or it's not. And, it is always in the same direction.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
