Posted by NCWayne on February 06, 2014 at 20:13:41 from (173.188.169.54):
Buddy of mine just got an '85 Chevrolet C70 truck with a 5 speed transmission and a two speed rear. That said there's no sticker or anything in the cab showing what the shift sequence should be, so he asked me this evening. Personally I've owned my share of vehicles, but nothing with the two speed rear, so I have to admit to being lost here when it comes to what to tell him. I asked my Dad as I knew he had one in his service truck about 80 years ago. He said best he remembered he kept his in high range all the time and never even used the low range. I've always heard you could do that unless you were towing a heavy load, etc and then you would probably need the low range to get going if nothing else.
All that said, what would be the typical shift pattern for an unloaded truck, medium loaded, and heavy (ie-towing around 15,000 lbs)? I figure there will be a variety of different ways to do things depending on the amount of load, road conditions, etc, and that ultimately it'll be the driver making the command decisions, but where would be the best place 'to start'? Thanks for any help ya'll can offer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
